Aeroplus 59" Trainer Ti (White/Red/Blue)

$750.00 $465.00
(You save $285.00 )
(No reviews yet) Write a Review
10.00 LBS
10.00 (cm)
125.00 (cm)
12.00 (cm)
Current Stock:

This is the new Aeroplus RC Ti Trainer PNP! Pre-installed Futaba full size servos , 5050-500KV brushless outrunner motor, 80 AMP ESC all installed! No glue is needed for the initial build! Just Screw on the landing gear, screw on the tail section and install your receiver! BIG indestructible wheels gives you a wide choice of runway options! Super smooth flying character gices this Ti Trainer a relaxing flight feel. When you are ready, Ti Trainer can turn up the performance and perform many 3D maneuvers! Beautiful covering and all laser cut wood with precision ball end pushrods and aluminum control surface arms. Wings are using a care free plug system and a single wing bolt thumb screw for each side. Battery can range from a 6s 3000 to 4500. 3300mAh is the best size for sport flying and light 3D. Tons of vertical power and just super fun to fly! Pushrods are installed and centered right out of the box! This Ti trainer can be flight ready from out of the box to flying in less than 15 minutes!



Wingspan 1500mm (59.1in)
Length 1280mm (50.4in)
Weight 1.2 kg / 2.6 ib (w/o battery), 2.8 Kg / 6.2 ib (w/ battery)
Wing area 34.5 dm2, 534.8 in2
Wing load 81.2 g/dm, 5.2 g/in2
Power System 5050-500KV brushless outrunner motor
Electronic Speed Control 80A (AS150 type connector) with 5A UBEC
Propeller 15×5.5 2-Blade

40g×2  Futaba Servo with 300mm lead (left & right ailerons)
40g×2  Futaba Servo with 300mm lead (elevator & rudder)

CG (Center of Gravity) 85mm from the leading edge of the Main Wing
Landing Gears E-PTU Tire Aluminium alloy Fixed Landing Gear
Radio System 4 channel (required & not included)
Battery 6S 22.2V 3300mAh 45C LiPo with AS150 type connector (required & not included)
Battery Charger 6S LiPo battery charger (required & not included)
Ailerons Yes
Elevator Yes
Rudder Yes
Flaps No
Lights No
Material Wood, High Quality Covering
Skill Level Beginner
Build Time 1 hours


  • 4+ channel radio system(4CH radio & 6CH receiver) (required & not included)
  • 6S 22.2V 3300mAh 45C LiPo with AS150 type connector (required & not included)
  • 6S LiPo battery charger (required & not included)